Validating ps3 dumps
We cannot guarantee the performance of system specifications below the minimum requirements but you're always welcome to experiment.
THIS IS IMPORTANT Set the switch on the Clip Edition to NOR. You don’t want to patch to 3.55 yet so press N, you also don’t want to byte reverse so press N again. After a little bit it will show you some quick results at the bottom. After you exit the program it’ll open up a webpage with the full results of the check, it also saves those results as an html file. If it says OK and the only errors you got with Bw E were for ROS0 and ROS1 you are probably good to go.
We have listed the minimum and recommend system requirements below.
For the best experience, users should be running within the recommended system requirements.
Now plug your Teensy 2.0 USB cable into your computer and the micro USB cable into the Clip Edition. If the binary comparison WAY-launchers does says that your dumps don’t match up then something about your setup isn’t working correctly, check the troubleshooting section. Leave your PS3 connected to everything and try not to disturb it, since we’re just going to have to write back to it in a minute. I included Norpatch that you can also check with, and there are others out there you can use. Now that you’ve verified that your dumps are good, now we can patch them.
Copy a from the NOR DUMP ORIGINAL folder, and paste those into NOR DUMP COPIES. You have the option of either patching for 3.55 or to patch to go to CFW.